4/12/2022
Remove Ram Slots
Pre-Removal Instructions Before removing the Memory Card: During installation or removal of any hardware always ensure all data is backed up properly. Disconnect any telephone, network, or USB cables from the computer. Disconnect the computer and all attached devices from their electrical outlets. Please remove the System Cover. Lift and remove the memory shield from the computer. Pry the retention clips away from the memory module until it pops up. Lift the memory module and remove it from the computer. Add Comment Cancel. Step 8 Removing the Memory Module.
Which Ram Slots To Use
Hi Guys,
I've got an Asus P5B Deluxe motherboard. Today I tried adding some new RAM to take it from 4GB to 8GB. The board is about 6 years' old. I've never used the black RAM slots before, only the yellow ones (2x2GB in slots 1 and 3).
My system only sees 6GB, not 8GB. I've tried various combinations of the RAM, get the same result.
To check the new RAM wasn't defective, I tried it in slot 1, a known good slot. All 4 sticks of RAM worked in slot 1, so the RAM wasn't faulty.
All 4 sticks work in every slot except slot 2 (the first black RAM slot). If I put any stick in slot 2 - old or new - the PC is dead, it won't even boot to the BIOS.
So it looks like I have a defective RAM slot.
Does anyone know of any way to fix this? The board is too old to RMA. I've tried an emery board down the defective slot, and I've tried squirting WD40 down it. No improvement.
Does anyone have any other ideas on how to get that bad slot working?
Thanks!
I've got an Asus P5B Deluxe motherboard. Today I tried adding some new RAM to take it from 4GB to 8GB. The board is about 6 years' old. I've never used the black RAM slots before, only the yellow ones (2x2GB in slots 1 and 3).
My system only sees 6GB, not 8GB. I've tried various combinations of the RAM, get the same result.
To check the new RAM wasn't defective, I tried it in slot 1, a known good slot. All 4 sticks of RAM worked in slot 1, so the RAM wasn't faulty.
All 4 sticks work in every slot except slot 2 (the first black RAM slot). If I put any stick in slot 2 - old or new - the PC is dead, it won't even boot to the BIOS.
So it looks like I have a defective RAM slot.
Does anyone know of any way to fix this? The board is too old to RMA. I've tried an emery board down the defective slot, and I've tried squirting WD40 down it. No improvement.
Does anyone have any other ideas on how to get that bad slot working?
Thanks!
Replacing Ram Slots Macbook Pro
- A2A How can you fix a RAM slot on a PC motherboard that doesn’t recognize RAM sticks? Assuming the other slots recognize RAM ok, and assuming the RAM that you are trying to insert in the bad RAM slot works fine in other slots, then the problem is.
- M.2 SSD, RAM and HDD upgrade options. After removing the service cover, you can access two free RAM slots, two free M.2 2280 slots, and a hard disk module and battery. If you need to access the heatsink, the fan, and the motherboard, you need to remove the entire back cover. This is a 2.5-inch hard drive module with a quick-swap design.